M2 Cinema Lens Adapter Spezifikationen PDF herunterladen (Seite 18)

Cleaning the DCX Lens

e DCX lens is located inside the M2 Encore.

If you are seeing a static aberration in your

footage, it’s possible there is dust on the DCX

lens. Cleaning the DCX lens should not be a

routine maintenance. It should only be done if

all other external surfaces, such as the glass of

the

microX, have already been cleaned and

examined.

1) Open-up the Encore’s top-lid by removing

the thumbscrews

2) Watch your picture, while you set the focus

of the camera towards the back (closest-by

setting)

3) Take a cotton-swab, and without touching it

with your ngers, rub it with a microber/lens

cloth until it get’s uy. Apply compressed air

to the same end.

4) Hold the swab between your nger tips,

angled towards the DCX lens (you might even

want to bent the swap slightly)

5) Use the uy swab to clean the front and

back of the DCX lens (through the little

iron grate (back) and just behind the rotating

groundglass (front)

Do NOT start blowing compressed air into the

compartment, or you will probably have to start

over again as something else may be blown up

and stick to it.

microTips:

The procedure above will also reduce the electrostatic load of

the condenser lens. Because the groundglass rotates through

the stationary air, an electrostatic eld is formed. It can be

both friend and foe; dust particles will stick to certain parts

of the mechanism and stay there, OR it will attach to the

condenser lens and stay there., which will than cause you to

repeat this cleaning routine.

Calibration and Maintenance

1 2 ... 13 14 15 16 17 18 19 20 21

Keine Kommentare

M2 Cinema Lens Adapter Spezifikationen Seite 18